2
$\begingroup$

Given A is upper limit of sand stone, B is the lower limit of the planes that are equal in distance and dip. Dip angle is 29 degrees.

Complete the outcrop of this map.

—————————————————————————-

Now I know that strike lines should go in height 400

But there are 3 points so how could that even be possible.

2 of these points are on strike line but what about the third?

I really don’t know how to approach this question

Also from dip angle I can easily find the distance from each strike line but that is for later enter image description here

$\endgroup$
4
  • 1
    $\begingroup$ What does the text at the bottom of your image say? $\endgroup$ – gerrit Apr 21 at 19:06
  • 1
    $\begingroup$ Given In the map above the upper limit A and the lower limit B of sand stone layer , you have to complete the limits of this layer the upper and the lower in all over the map , the dip of all layers is constant and the thickness between them is constant , you have all the information to solve the question . Additional information : ( dip angle 28 degrees ) $\endgroup$ – Mather Apr 21 at 19:15
  • $\begingroup$ I have translated it accordingly $\endgroup$ – Mather Apr 21 at 19:15
  • $\begingroup$ In the map upper left Scale 1:10000 cm $\endgroup$ – Mather Apr 21 at 19:17
3
$\begingroup$

enter image description here

First step - draw a strike line where line A intersects the 400 m line.

Second step - you know that the sandstone layer is of equal thickness and dip, so you can draw a parallel line at the place with line B intersects the 400 m line. This will give you the thickness, as expressed on a horizontal surface. You know what the dip angle is, so getting the real thickness is simple trigonometry.

This should get you started.

$\endgroup$
11
  • $\begingroup$ Can you add more hints , after getting the thickness What should I do ? Probably getting the other strike lines from that thickness but how $\endgroup$ – Mather Apr 20 at 2:40
  • 1
    $\begingroup$ @Mather each strike line will be equispaced, so it's just a matter of finding where each strike intersects its respective altitude line. $\endgroup$ – Gimelist Apr 20 at 5:57
  • $\begingroup$ Can you show that on the map , for example if the thickness is , t = 5 cm , where should I draw strike line 500 , 600 . 5 cm from the right of strike line 400 at A ? Or to the left ? Or at B ? So many options $\endgroup$ – Mather Apr 20 at 6:26
  • $\begingroup$ I feel like I should put strike at B-500 , then using the distance from A400 to B400 , I can also say it’s the same distance from A500 to B-500 , without calculating the thickness $\endgroup$ – Mather Apr 20 at 6:31
  • 1
    $\begingroup$ @Mather you have the place where line B intersects line 500. It's a bit to the right of my red line "2". This is the horizontal distance between strike lines. It is the same distance for the top and the bottom of the layer. $\endgroup$ – Gimelist Apr 21 at 6:03

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.